Plugable USB 2.0 2-Port Hub/Splitter circuit board dimensions

James9 · April 21, 2015, 6:41pm

What are the dimensions of the Plugable USB 2.0 2-Port Hub/Splitter circuit board (PCB), not including usb ports. I am considering using it in an embedded application, so I will be removing the usb ports. This is to be fit into a small case for a portable device, such as the raspberry pi, so I need to know how much space it occupies. If possible, could you give the maximum dimensions in length, width, and height, including the components, except for the usb ports. If you can’t do that, then just pcb dimensions. Thanks.

David_Roberts · April 29, 2015, 12:25am

HI James,

The dimensions of the PCB without the USB ports are as follows.

Length: 41mm (28mm if you cut the board after the pads for the USB port lines after removing the ports. No guarantee this would work).
Width: 17mm
Tallest component (crystal) from lowest part of PCB: 10mm

I’ve attached some photos.

system · September 13, 2018, 2:06pm